Product

SmartShopper

Voice created shopping lists

The assembled SmartShopper device: its LCD shows a shopping list with COFFEE, ICE CREAM and TOILET PAPER above the blue RECORD button, with a box of replacement thermal paper rolls beside it

In December of 2005 Anpeco was asked about developing a product that users could hang on a refrigerator, speak to add items to a shopping list, and then press a button to print the shopping list before going to the grocery store.

We researched the various components we would need to implement such a product. We found Nuance had a speech recognition beta that could run on BlackFin DSP chips from Analog Devices. We found a French company producing a small, low cost thermal printer suitable for printing shopping lists. We planned out the power usage, starting with 6 AA batteries and a plan to only run the BlackFin DSP for short time periods doing speech recognition. For the main control we chose a very low power Atmel microprocessor that would allow the device to hang on a refrigerator using virtually no power when not being used, allowing for many months of battery life.

After planning out the components and design steps, we replied back with a projected cost of the final product along with NRE costs and an aggressive development timeline of less than a year. We accepted the project and initial payment in January of 2006. In spring of 2006 we did schematics, PCB layout, mechanical design, firmware, and even PC software to optimize the speech recognition. Using the PC software we recorded about 10 people reading all 2,600 items the device would recognize. We could then tweak the speech software parameters and run all 26,000 recorded phrases through the software to optimize the results.

In August of 2006 we took our design to China to meet with 3 factories our China contacts had identified to produce the product. By November we had produced 20K units that quickly sold out. In the next year almost 500K units were produced and sold. In the end the unit price was 30% below our original estimate and the design was in manufacturing in 9 months instead of the estimated 12 months.

Speech recognition

A Nuance speech recognition beta running on BlackFin DSP chips from Analog Devices.

Prints the list

A small, low cost thermal printer from a French company, built for printing shopping lists.

Power

6 AA batteries, with the BlackFin DSP running only for short speech recognition periods.

Main control

A very low power Atmel microprocessor: virtually no power when idle, for many months of battery life.

Tuning the voice

PC software recorded about 10 people reading all 2,600 items, then ran all 26,000 recorded phrases to optimize the results.

Manufacturing

Took the design to China in August 2006 and met 3 factories; 20K units by November, almost 500K in the next year.

The assembled SmartShopper device on a wooden table: its LCD shows a shopping list with COFFEE, ICE CREAM and TOILET PAPER, next to a box of replacement thermal paper rolls
The finished device with a box of replacement thermal paper rolls.
Two SmartShopper circuit boards on a wooden table: the display board with its LCD and push buttons above the main board carrying the Analog Devices BlackFin DSP
Inside the device: the display board and the main board with the Analog Devices ADSP-BF531 BlackFin DSP.
Circuit board layout screenshot of the SmartShopper V4 board: a contoured single-board design with the LCD cut-out in the middle and red and blue copper traces
Board layout for the SmartShopper V4 redesign, with the LCD cut-out in the middle.
Circuit schematic sheet for the SmartShopper Version 4, showing the Analog Devices BlackFin DSP and its connections to the audio codec, flash and SDRAM
Schematic sheet 2 of 7: the BlackFin DSP and its audio, flash and SDRAM connections.